netsh interface ipv4 set address name=Interface_Name source=static addr=Public_IP mask=255.255.255.0.Even if you run a static LAN IP (preferred), with this setup it is required to configure region.ini with a local IP of 0.0.0.0 else it might still fail.įrom a commandline it would look something like : close the error with x and hit ok to apply the settings. When you hit ok, it gives an error about missing subnet, and fills one by itself. 3.On the General tab, click Use the following IP address, and then type the IP address without subnet mask / gateway / DNS (so just the IP, like 64.31.16.122 ).2.Click Internet Protocol (TCP/IP), and then click Properties.1.On the host operating system, open Network Connections, right-click the local area connection for Microsoft Loopback Adapter, and then select Properties.Now configure the adapter with your public IP address : 6: Congratulations! You have now successfully enabled the loopback adapter. Next choose Microsoft KM-TEST Loopback adapter, and click Next until it’s finished. 5: Navigate “Microsoft” from the left pane under the manufacturer section.4: Now choose “Network adapters” and click Next.3: From the “Add Hardware” window, click on “Install the hardware that I manually select from a list (Advanced)” and after that click Next.2: From the device manager window, click on action, and then from the drop down box, click on “Add legacy hardware”.From the displayed results, tap on the “Device Manager”. 1: In the search bar, right next to the Windows icon, type “Device Manager”.Installing the KMS NAT Loopback Adapter (Windows 10) Installing NAT loopback when you don't need it, can cause connectivity issues. Veryfiy that all is correctly set prior to continueing. This tool will help you test your configuration: simulatortoolhelper. We cannot promise any of these with work in your particular network, but people have reported successes with workarounds in the guides below.īefore you start making changes, make 100% sure the issue IS an actual NAT loopback problem. Read more here Below are some workarounds and guides. This is defined as a "NAT Loopback issue. You read this because you have run into a problem where outside users can connect to your region, but you cannot get in from within your local network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |